BASIC Stamp II compatible, Direct access to
any pin or register, automatic page boundary handling past 2K, Real
If..Then..Else..Endif, Built-in LCD support, I2C instructions to access more
external devices including serial EEPROMs.
Note:
We don't waste time with square wave or modified sine
wave, all our kits is pure sine wave!
The Power
stage needs no PCB it is mounted on a heat sink and hardwired.
DIY Options.
Kit
1: From 300 watt to 10 Kilo watt Inverter only.(2 Kw. stags.)
Ready
made and populated control PCB that can be connected to a set of
parallel power output transistors. One pre-programmed MCU that is generating a sine
wave into a driver from where you get your signal to drive a set of power transistors, up to 20 or more in parallel depending on your
wattage needs. Full easy to follow assembly instructions of the
power stage.
Kit 1.
$129 USD
Kit 2:
From 300 watt to 10 Kilo watt UPS functions.(2 Kw. stags.)
Ready
made and populated control PCB that can be connected to a set of
parallel power output transistors. Two pre-programmed MCU's the
first MCU do all the control of the
inverter with a LCD display and other functions like monitoring of the mains
that will automatically start your inverter when the power fail, charging
control and voltage regulation. The second MCU do the same as version one.
That is generating a sine
wave into a driver from where you get your signal to drive a set of
power transistors, up to 20 or more in parallel depending on your
wattage needs. Full easy to follow assembly instructions of the
power stage.
LCD display additional.
From 300 watt to 10 Kilo watt Inverter only
(2 Kw. stags.)
One MCU that is generating a sine
wave into a driver from where you get your signal to drive a set of power transistors, up to 20 or more in parallel depending on your
wattage needs. Full easy to follow assembly instructions and
diagrams of the
power stage.
We supply a CD with the HEX code for programming the MCU's, included
on the CD is the Gerber files, and diagrams for all PCB's
manufacturer ready and assembly instructions, we can supply a ready
programmed chip or we can supply a USB programmer for the MCU's.
From 300 watt to 10 Kilo watt UPS
functions.(2 Kw. stags.)
Two MCU's the
first MCU do all the control of the
inverter with a LCD display and other functions like monitoring of the mains
that will automatically start the inverter when the power fail, charging
control and voltage regulation. The second MCU do the same as Kit one.
That is generating a sine
wave into a driver from where you get your signal to drive a set of
power transistors, up to 20 or more in parallel depending on your
wattage needs. Full easy to follow assembly instructions of the
power stage.
We supply a CD with the HEX code for programming the MCU's, included
on the CD is the Gerber files, and diagrams for all PCB's
manufacturer ready and assembly instructions, we can supply a ready
programmed chip or we can supply a USB programmer for the MCU's.
Only one license will be issued in each country!
$5900
USD Per Country this license include Kit 1 and Kit 1 will not be
sold to any other party in the same country
No
need for a power supply, it draw its power from the USB port on your PC.
Drivers are included on the CD or can be downloaded free from the
internet, can program most of the flash type PIC devices with ICSP .
No
need for a power supply, it draw its power from the USB port on your PC.
Drivers are included on the CD or can be downloaded free from the
internet, can program most of the flash type PIC devices with ICSP .
